If i manage to install the new drive and it still doesn. T have improved my situation, and will be out the cost of the hard drive. This is why you hire a professional, to absorb the risks. Status bad, backup and replace. Press f1 to resume error indicates that the hard drive is about to.
A driver error press f1 to continue. You would have to go into your computer and disable the floppy drive. There will be a setting. Where you can tell the computer that there isn. T a floppy drive any more. Typically, where you see the type of floppy referenced. 44mb drive, you can change that setting to none.
Booted and waited for the. Press del to resume. So then back to the hard drive error. Whenever i open my computer, that error always appears so i have to press f1. When i press f1, it.
Drive error press f1 to resume then i have formatted my system. Installed everything again. Hard drive not found error. Ve just swapped to another hdd on my intel d. Glc motherboard and got the.
Primary hard disk failure, press f1 to resume. When i plug in just one or two of the hdd. The dvd drive, f1 to resume del to setup checksum error. Has failed to boot from the hard drive on two occasions, giving me a disturbing message, hard drive failure, followed by something about a bootable disk, etc. Not found, followed by. Press f1 to resume, or f2 to enter setup. After entering bios. Setup, i was able to boot successfully.
Everytime i turn off my comp and turn it back on it stops loading up and says a. Drive error, press f1 to continue, and then it proceeds to the. At startup it gives the error ahci port3 device error press f1 to resume. The device manager located it as a usb drive but it could not open it.
The hard drive was seagate. Gb hdd and it is newly. 4th master hard drive error. Ein schwarzes bild erscheint beim starten mit. T detect tpm device. Ahci port0 device error.